Voco Ufi Gel Hard

Ufi Gel Hard and Ufi Gel Hard C

Ufi Gel Hard and Ufi Gel Hard C

Ufi Gel Hard C - Direct hard relining material perfectly mixed from the cartridge for simple, time-saving and bubble-free application

Ufi Gel Hard is the Handmix version of Ufi Gel Hard C

INDICATIONS:

• Hard permanent relining
• Direct and indirect relining
• Total or partial relining
• Ambulant relining
• Lengthening of denture rims
• Repair and enlargement of dentures
• Correction of new dentures

FEATURES:

• Only one appointment required
• Methylmethacrylate-free
• Neutral taste and odour
• No heat development in the mouth
• Good color stability
• As easy as taking an impression
• Lower costs for your clinic
• Aesthetic, high patient acceptance and comfort
• Smooth surface
• New layers can be added at any time

INDICATIONS:

• Hard permanent relining
• Direct and indirect relining
• Total or partial relining
• Ambulant relining
• Lengthening of denture rims
• Repair and enlargement of dentures
• Correction of new dentures.
• 
  
• Packaging:
• 
  

• Voco Ufi Gel Hard Set

  • 1 x Powder 60 g
  • 1 x liquid 40 ml
  • 1 x Conditioner 20ml
  • Accessories

  Voco Ufi Gel Hard C -Set Cartridge 80g

  • 1 x 80g Cartridge
  • 1x 10ml bottle

Directions To Use :

Application of Ufi Gel hard

• Apply the material evenly onto the prepared margin and/or base of the denture with a plastic spatula.
• Prevent build-up of excess material, remove with a suitable instrument if necessary.
• Re-insert denture and have the patient exert slight pressure in terminal occlusion for 1 min.
• Then carry out functional, chewing and swallowing movements for 2 min.
• Ensure that no material flows into the throat when relining an upper denture, especially at the transition from hard to soft palate (A-line).

Partial and total denture with undercuts

• Remove denture 5 min after commencement of mixing and remove excess material immediately with scissors or a scalpel.
• Insert again into the mouth for a final occlusion check and allow to cure for about 2 - 3 min.
• Instead of re-inserting the denture, curing can also be completed in warm water, e.g. in a pressure pot at approx. 40 °C.
• Do not let the material cure in contact with air since atmospheric oxygen will cause an uncured inhibition layer on the surface.

Total dentures without undercuts

• Excess material can be removed intra- or extraorally before final polymerisation.
• Intraorally: remove excess material after 5 min (from beginning of mixing) with a suitable instrument.
• Let the denture cure for further 2 - 3 min in the mouth until Ufi Gel hard is completely cured.